During the summer months one of the most common problems with air conditioning systems is getting low on freon. This is a qoute that ordinarily ends with the air conditioning undertaker of a package deal putting a few pounds of freon in and calling it quits. This is not the accurate way to solve the solution, and never a fix that will last forever. By going through the next steps I have in case,granted in this description you can warrant your air conditioner will work next year.
The way an air conditioning ideas works is by using a refrigerant (freon) and letting it turn its state to take the heat out of the air. This refrigerant is in a sealed ideas which should never have to be supplanted or recharged. When a permissible factory of an air conditioner is performed the undertaker of a package deal should put a vacuum on the ideas to check for any leaks. If there is a leak in the ideas it needs to be found and repaired. This is where the qoute ordinarily comes into effect. While the factory process whether someone had a bad braze weld or didn't put a vacuum pump on and there is a leak.
Air Conditioner
This leak could go undetected for a few years and by the time the buyer notices it there is no more warranty on the stock or installation. When another undertaker of a package deal comes in to look for the qoute they just fill it up and take the easy money. This fee to fill with freon can range from 0-5 and after doing that a few times the buyer can spend more than the ideas is worth. Not to mention the damage the low freon will do to your compressor and cause time to come problems.
The permissible thing to do in the case of a loss of freon is very easy, and after the fix you can be sure that you will never lose freon again.
What you need to see the compact rod is put the ideas into a inevitable pressure using nitrogen. By putting that much pressure in the ideas you will be able to hear the nitrogen leak and fix the problem. If the qoute is in the exterior or inside coils you need to have them replaced. Hopefully the leak was in one of the primary welds and can just be touched up. After the fix there needs to be a vacuum put on the system. By bringing the ideas to a negative pressure you remove all of the noncondensables and any moisture in the system. Let this vacuum sit for an hour and see if there is any loss. If not recharge to factory standards and you air conditioning ideas will work well for a long time.
Air Conditioner Freon Leak Repairs